Matt Cote

  • Total activity 194
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 3
  • Subscriptions 97

Activity overview

Latest activity by Matt Cote
  • Matt Cote created an article,

    Bluetooth Dongle - Set Up summary Page and Download

                 Command Mode Connect the Firefly to the Serial Port on your PC, or use an RS232 to USB adapter. Run TeraTerm, Putty or other terminal emulator software. Open a Com window to the Co...

  • Matt Cote created an article,

    BF-850 Driver

    Driver for BF-850: BF-850 (USB <---> RS485/RS422)  

  • Matt Cote created an article,

    My Smart Outlet does not appear in the list of devices

    If the Smart Outlet does not appear in the list of devices during configuration then you will need to perform a reset on the unit.  Depress the two manual outlet control buttons on the side of the ...

  • Matt Cote created an article,

    Error: Call WIN32 Function Failed

    This error is related to the RF Module performing a device search on a Com Port created for a USB connection. It is most often seen when using a serial/USB adapter to connect the ATC unit through a...

  • Matt Cote created an article,

    Part No. - PCAN-USBx6 Power Connector

    The PCAN USB x 6 uses a green, 2-terminal Phoenix connector for the power supply input. These are available at www.digikey.com.   Phoenix mating connector: 2-pole, pitch 3,81 mmPhoenix Contact MC1,...

  • Matt Cote created an article,

    Security Probe 5ES-X20/X60

    Security Probe 5ESV-X20/X60 - Manual  

  • Matt Cote created an article,

    Security Probe 5ESV

    Security Probe 5ESV - Manual

  • Matt Cote created an article,

    Security Probe 5ES

    Security Probe 5ES - Manual  

  • Matt Cote created an article,

    Can I attach the sensor accessories directly to a switch or router?

    No, the sensor modules are not Ethernet and will not operate through a direct network connection. They are intended to be connected to a Sensor Probe or Security Probe base station. 

  • Matt Cote created an article,

    How do I use the sensors?

    The sensor modules are intended to be used with the Sensor Probe or Security Probe base units. There are attached via RJ45 (non-Ethernet) cable connections and are auto-detected by the base.